Work done
on our bench.
Optics mounted and bore sighted. Sights fitted. New York compliance handled. You get a repair estimate and an approximate hour range before work begins — and if the job turns out bigger than that, we call you.
No surprises. That’s the whole policy.
Three steps, and you know the cost before anyone picks up a tool.
Drop it off unloaded and cased, or call us first and we’ll talk it through. Tell us what it’s doing and what you want it to do.
We look it over and give you a repair estimate with an approximate hour range before any work begins. Estimates are good for 30 days.
If the job turns out bigger than the estimate, we stop and call you. Nothing goes on your bill without a yes from you first.
You’ll know the cost, and the hour range, before anyone picks up a tool.
Common jobs & what they run
These are the jobs we do most, priced flat where we can. Anything not on this list gets quoted from the bench.
Cleaning & inspection
- Basic gun cleaningPriced on complexity$40–$80
- Gun safety inspection$20
Optics & sights
- Rifle scope mountingIncludes bore sight$60
- Pistol red dot mountingIncludes bore sight$45
- Pistol iron sight install$60
- Pistol iron sight installWhere fitting is required$85+
- Bore sighting only$15
Pistol work
- Pistol trigger install$65+
- Glock trigger spring swap5 lb spring included$45
New York compliance work
- Muzzle device pin & weld$46
- Fake A2 brake, pinned & weldedBrake supplied$60
- Magazine pinning, where possiblePer magazine$25
A note on pricing. A + means the price starts there and depends on fitting time. Parts are additional unless the line says the part is included. Prices are subject to change — your written estimate is the number that counts.
Below is the repair policy exactly as it prints on your work order — pulled live from our records, not retyped here. If it changes at the counter, it changes on this page the same day.
Not sure what it needs?
Bring it in, or give us a call. Either way you’ll know the cost and the hour range before anyone touches it.